Most of us look to save where we can, especially in this day and economic conditions. House painting is no different, when it comes to saving money. A home exterior weathers from harsh elements of heat, cold, sun, and snow, and exterior paint ages over time needing repainting. Exterior trim, being that of solid wood is normally the first to show signs of painting maintenance. Many times a homeowner happens to call, asking for only painting the trim. Trim paint jobs sound good at first, but have some underlying thoughts may have not been considered. Below are things to consider when considering painting trim only.
Inside the house is where acrylic shines. It dries faster than other types, and it keeps its color better, without yellowing. One disadvantage: It costs more.
You'll need a large compressor, not just the typical 20 gallon variety most of us have. This is a 60 gallon, vertical compressor with typically a 5+ hp motor. Then you'll need a decent paint gun (possibly 2; one for primer and one for color) which again is an expense. Then there's the question of where you'll paint the car. Renting a paint booth is best, but can be expensive and hard to find. You can always seal up your garage or shoot out in the wetted down driveway, but you'll inevitably get dirt and moisture into the paint.
The reasoning here is simple. Every color in the visible spectrum can be assigned a number based on a luminosity scale (a scale from light to dark) from 0 to 9 where white is 0 and black is 9. Now suppose that the brown you are trying to cover has a score of 8, and the yellow paint you want to apply has a 4.
Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled.
Fortunately, you can always get your primer tinted for free. Getting your primer colored the same as your paint will save you a coat of paint. Of course, I always recommend doing a minimum of 2 coats of paint so that your finish sheen looks consistent.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.