If you have a vinyl top then remove the molding separating the vinyl and paint. Drip rail chrome really should be removed also, but can be extremely hard to take off undamaged. If you plan on buying all new drip molding then definitely remove the old for painting. But if you want to keep the originals then it might be better to leave them on and let the painter mask around. If you have hub caps it's easy to just take them off. While the paint shop should completely mask all four tires, overspray can still find its way in. It's sometimes better to play it safe and just remove wheel covers.
If you are grappling with the problem of choosing a woodwork colour to go with neutral walls, check out Architectural Colours by David Oliver, the founder of Paint & Paper Library. He arranged his off-whites for ceilings, cornices, walls and woodwork in chromatical groups and the concept has been so well received that chromatically arranged colours, such as soft greys, greens and pinks, have been introduced.
Solvent or oil-based paints are used where a tough, durable finish is required for interior and exterior timber, masonry and furniture - although, as mentioned above, the new generation of acrylics and multi-surface paints offers viable alternatives. In general, brushes need to be cleaned with turpentine or white spirit.
New Paints Give You Pro's Skill. Painting your house will be easier than ever - if you get the right paint. But it's going to be harder than ever to pick it.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
Paint Selection. Most paints are purchased ready-mixed but, in their selection, consideration should be given to the fact that surfaces vary in their adaptability to paint and atmospheric or other conditions having an adverse effect on paint performance. In addition to the normal weathering action of sun and rain, outside house paints are sometimes exposed to other attacking elements, such as corrosive fumes from factories or excessive amounts of wind-driven dust.
Once you figure out which position is prime and which position is spray, place the valve in the prime position and grab the primer hose. Point the primer hose in the empty bucket near the top and at an aproxx.45 degree angle from the side (the reason for this is that there is likely to be pressure still built up in the airless and when you first switch on the airless to prime it, paint will likely burst out of the primer hose and you don't want to have it go everywhere). Now turn the airless paint sprayer on and you will see that the airless is sucking up the new paint and pumping out the primer hose. At first you will typically see a cleaning solution come out followed by your paint. When you see your paint coming out switch over the primer valve to the other position and you will see the airless pumping paint into the main hose.